Dashed or Dotted Line

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
Matthew
Posts: 18
Joined: Thu Oct 15, 2015 1:44 am

Dashed or Dotted Line

Post by Matthew »

Is it possible for the software to create a dotted or dashed line from an imported DXF line that is solid and is used for cutting? I can't quite understand what the DOT function is doing in the manual, but it appears to be for scanning.

What I'd like is to import a DXF line drawing, and then have the laser cut that line using (for example) 2mm on, 2mm off. This would create perforation effect.

Thanks
User avatar
Matthew
Posts: 18
Joined: Thu Oct 15, 2015 1:44 am

Re: Dashed or Dotted Line

Post by Matthew »

I understand this now. the dot mode will indeed allow the creation of perforated lines.
User avatar
LINUS
Webmaster
Posts: 263
Joined: Tue Apr 28, 2015 3:55 am

Re: Dashed or Dotted Line

Post by LINUS »

:) Good
Post Reply