Visible Red dot pointer --- 20160122

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
Alexandre
Posts: 24
Joined: Wed Oct 14, 2015 9:33 am

Visible Red dot pointer --- 20160122

Post by Alexandre »

Hi Tom

Seems I do have problem with the red dot pointer.

It's not visible on the work surface any more.

See pictures. Dosn't make a rond shape at the exit of the gizmo so dosen't have power when arrive at the 2 miroir and at the 3 one...almost nothing.

Try to adjust the focus wheel on the laser gizmo but can't make it better.

Best Regards
Attachments
20160121_121736.jpg
20160121_121736.jpg (781.26 KiB) Viewed 4305 times
20160121_121647.jpg
20160121_121647.jpg (314.35 KiB) Viewed 4305 times
Concept et Patentes
ALX Lemay
Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: Visible Red dot pointer

Post by Thunder Laser -Nolan »

Hi Alex,
1. pulse a dot on the adhesive tape at the third mirror mound. (picture 1)
the red dot and central dot have no overlap this time.

2. try to adjust the screws at the red dot pointer mound. (picture 2)
for example, tighten the 1st screw(rotate right), the red dot will remove to left down position.

any question, please ask us again.
Attachments
2.png
2.png (336.73 KiB) Viewed 4269 times
1.png
1.png (350.8 KiB) Viewed 4269 times
User avatar
Alexandre
Posts: 24
Joined: Wed Oct 14, 2015 9:33 am

Re: Visible Red dot pointer

Post by Alexandre »

Hi Tom

The red dot just came back :D ....I did have a power problem at the same time....It seems the focus lens wasn't sit properly in the lens holder....
Just read in your manual...need to have a " o ring" I did not see any...normal?

Other question for you... let say I have a 2 layers job ....layer blue is for cutting so i select AIR ON and my layer red is for just making the top of material so I select NO AIR.

Sart the job by layer order ....Red first then blue in second
As soon the job start....the air blow from the beginning to the end ....job finish....5 sec delay...stop

Best Regards
Attachments
20160120_132353.jpg
20160120_132353.jpg (458.22 KiB) Viewed 4257 times
2016-01-21 21.57.59.png
2016-01-21 21.57.59.png (292.43 KiB) Viewed 4257 times
Concept et Patentes
ALX Lemay
Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: Visible Red dot pointer

Post by Thunder Laser -Nolan »

Hi Alex,
1. the "o ring" is inside the lens holder, it is used for fixing the focus lenses.
I think the power problem has nothing to do with it.

2. I know the "air on/off" option on software, and yes, it will air on always.
because our hardware don't support this function.
Post Reply