Page 3 of 3
Re: Mars 90 cutting problems
Posted: Wed Aug 31, 2016 7:42 pm
by Alexandre
- under the focus lens.jpg (423.37 KiB) Viewed 2489 times
Re: Mars 90 cutting problems
Posted: Thu Sep 01, 2016 3:27 am
by Thunder laser - Tom
Hi Alex
The testing of laser tube is still our old laser tube(you ordered it as a spare part from thunder laser?)
If so, it has been already keeping about 8-9 months in your stock
So now it's getting 100Watt power that's ok, at least my experience it's normal after keeping for a long time
I trust you have checked all the factors for the laser now
Please just do one more time, it's check the vertical of a laser beam from laser head to the material
How to check? do you have a 10mm thick acrylic in your stock? please put it at four corners of the laser
and then laser a line on it to see if there's four vertical lines at the acrylic as the attached picture shown
If your laser is also working fine as the picture shown, it proves the laser does the work fine always
We can only set a low speed to cut it through, i don't know how the hard of a Russia plywood
But we have no a better idea to make it faster to cut.