Size wrong

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
Matthew
Posts: 18
Joined: Thu Oct 15, 2015 1:44 am

Size wrong

Post by Matthew »

I am cutting a part that is 177mm wide, but when it comes out, it's about 176.3mm. Some of this is kerf (about 0.2mm diameter). But even if I account for kerf, the cut size is still off.

How can I specify the steps/mm of the system?

Thanks
Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: Size wrong

Post by Thunder Laser -Nolan »

Hi Matthew ,
Here is the troubleshooting link can solve you problem
http://www.thunderlaser.com/troubleshoo ... -size.html
User avatar
Matthew
Posts: 18
Joined: Thu Oct 15, 2015 1:44 am

Re: Size wrong

Post by Matthew »

How do I know my password for vendor settings?
Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: Size wrong

Post by Thunder Laser -Nolan »

Password:rd8888
Post Reply