Page 2 of 2

Re: Not accurate cutting problem.

Posted: Wed Sep 21, 2016 10:44 pm
by Young
Hey Ben!

Thank you for your quick reply.
Here is a photo.
We cut a bear shape which is a symmetrical shape.
We cut it in a half. It means that two half of bear shape should be the same.

But, there are differences. the gap is 2~2.5mm.
We checked the level of the cutting board again. And, it is ok.
And, the bear shape cut in left part of cutting bed is symmetrical.

Re: Not accurate cutting problem.

Posted: Thu Sep 22, 2016 12:47 am
by Ben
Hi Joon,
Thanks for your picture.
Okay, the gap is 0.2~0.25mm.
please create a circle by RDworks and cut it, if it is the same problem.

Re: Not accurate cutting problem.

Posted: Thu Oct 13, 2016 10:11 pm
by Young
Hey.

Thanks for your suggestion.
I was too busy to have a test.

So, I have just taken a test.
I drew the circle in Laser program you provided.
And cut the circle.
You might see the differences.
The difference is 1mm.

Is that a problem? If it is, do you have any suggestion to solve the problem?

Thanks in advance.
Joon

Re: Not accurate cutting problem.

Posted: Tue Oct 18, 2016 2:25 am
by Ben
Hi Jooh,
sorry for our late reply.
For your problem,there are still three checking you can do.
1.make sure the belt is tight enough;
2.find below link to improve the problem.
http://www.thunderlaser.com/troubleshoo ... -size.html
3.cut a 150×150 square,check if the diagonal is equal.
square.png
square.png (399.28 KiB) Viewed 4834 times

Re: Not accurate cutting problem.

Posted: Wed Dec 07, 2016 2:44 am
by Young
Hey,

Please, let me know the vendor password.

Re: Not accurate cutting problem.

Posted: Wed Dec 07, 2016 8:55 am
by Thunder Laser -Nolan
rd8888