3D engrave

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder Laser -Nolan, Thunder laser - Tom

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: 3D engrave

Post by Thunder Laser -Nolan » Fri Dec 09, 2016 12:33 am

Hi Jasper_Rullman
you can mirror and rotate your image when using the rotary table.
Rotate 90 or 270 degree and do the Horz mirror or Vert mirrror to get the correct orientation you wanted,
and then save the file as that orientation so you not need to do it again when you reuse this file.Ok?

Jasper_Rullman
Posts: 11
Joined: Fri May 15, 2015 2:48 am

Re: 3D engrave

Post by Jasper_Rullman » Fri Dec 09, 2016 6:42 am

Thank you for the information, I just wanted to be 100% clear, it is expected to have to have to Mirror any image to be used with the rotary table. Just surprised that is not documented in the RDWorks Manual.

Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: 3D engrave

Post by Thunder Laser -Nolan » Mon Dec 12, 2016 5:42 am

Hi Jasper_Rullman
Thanks for you suggested.
it will help us to improve our software.
Hoping you everything is well.

Post Reply