Re: 3D engrave
Posted: Fri Dec 09, 2016 12:33 am
Hi Jasper_Rullman
you can mirror and rotate your image when using the rotary table.
Rotate 90 or 270 degree and do the Horz mirror or Vert mirrror to get the correct orientation you wanted,
and then save the file as that orientation so you not need to do it again when you reuse this file.Ok?
you can mirror and rotate your image when using the rotary table.
Rotate 90 or 270 degree and do the Horz mirror or Vert mirrror to get the correct orientation you wanted,
and then save the file as that orientation so you not need to do it again when you reuse this file.Ok?