Engraving a line

We provide online after sales support here, very quick reply.

Moderators: baker, Thunder Laser -Nolan, Thunder laser - Tom

Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Post Reply
User avatar
Posts: 24
Joined: Fri Jun 17, 2016 8:25 am

Engraving a line

Post by stevenresnick » Sun Dec 04, 2016 5:29 pm

Is there any way to engrave a line or a stroke in RDWorks???

Thunder Laser -Nolan
Posts: 84
Joined: Fri Jun 05, 2015 8:18 am

Re: Engraving a line

Post by Thunder Laser -Nolan » Mon Dec 05, 2016 3:29 am

You can draw a little height rectangle or draw line layel setting select cut but speed faster,power low
setting.jpg (27.97 KiB) Viewed 1991 times

Post Reply