Page 1 of 1

Laser Engraver

Posted: Fri Dec 23, 2016 7:55 pm
by laser10
Hi
I am new to the laser engraving subject, however I am looking for a small desktop, and preferably cheaper, laser engraver. I am going to be using the engraver to manufacture ID's and access cards for my employees. An expert I talked to suggested that poly carbonate film is good for security purposes and that's why I was planning to use it. I am not sure if I can buy any engraver, or if there is any specific company's that produce engravers for poly carbonate. I am also not sure about what company's produce good quality engravers and I was hoping someone could give me some general advice on the subject. Thanks

Re: Laser Engraver

Posted: Mon Dec 26, 2016 7:27 am
by Thunder Laser -Nolan
Hi Sir or Madam,
I am yumiko from thunderlaser,may I know how thick for your poly carbonate are you going to cut?
and may I know where are you from?
for poly carbonate,engraving by laser machine is no problem,however,cutting is not good.
As we have client from Australia by our machine do this material,thanks.

best regards
yumiko
email:yumiko@thunderlaser.com

Laser Engraver

Posted: Sat Oct 21, 2017 2:59 pm
by Zachcosi
In use there is little force on the bearing - the laser exerting no cutting force - the design seems to rely on Loctite to retain the bearing against a shoulder