Please Help No Power to machine

General knowledge about laser here.

Moderator: baker

Post Reply
powl4evr
Posts: 4
Joined: Tue Mar 07, 2017 6:41 pm

Please Help No Power to machine

Post by powl4evr » Tue Mar 07, 2017 7:55 pm

I have a kehui 100w laser engraver. Last week it just shut down. It appears that there is no power to the machine. There is power to the outlet, tried a different power cable, checked switches and emergency shut off switch, all appear good. Ordered a new power supply and installed it today, still nothing.
Please does anyone have any ideas why this is happening.

Thank you,
Shawn

powl4evr
Posts: 4
Joined: Tue Mar 07, 2017 6:41 pm

Re: Please Help No Power to machine

Post by powl4evr » Thu Mar 09, 2017 12:14 am

Ha, stupid me. Found a very hidden fuse. Problem solved

User avatar
LINUS
Webmaster
Posts: 234
Joined: Tue Apr 28, 2015 3:55 am

Re: Please Help No Power to machine

Post by LINUS » Thu Mar 09, 2017 1:33 am

bless you
Because of major,be at ease so.

Angelasundy
Posts: 3
Joined: Fri Mar 31, 2017 8:10 pm

Re: Please Help No Power to machine

Post by Angelasundy » Fri Mar 31, 2017 9:23 pm

Where is the hidden fuse this is the same issue our power works everywhere but the control panel please help

User avatar
LINUS
Webmaster
Posts: 234
Joined: Tue Apr 28, 2015 3:55 am

Re: Please Help No Power to machine

Post by LINUS » Sat Apr 01, 2017 3:47 am

hidden fuse in connection socket at the rear side
Because of major,be at ease so.

Post Reply