General knowledge about laser here.

Moderator: baker

Post Reply
Posts: 2
Joined: Thu Oct 05, 2017 2:59 pm


Post by philbob » Thu Oct 05, 2017 3:10 pm

hi all so im new to the laser cutter iv googled and googled but im still unsure on the power for it ok so its a k40 off ebay it came with a 2 pin plug,then on the unit its got a 3 pin hole so could i use a uk 3pin plug on it and will it work right.thanks for any help from you guys

Posts: 5
Joined: Thu Nov 23, 2017 1:39 am

Re: power

Post by ve3sqb » Thu Nov 23, 2017 2:26 am

It will work but I would put a whole new cable on it and ground the case. It's always a wise electrical thing.

Post Reply