Page 1 of 1

power

Posted: Thu Oct 05, 2017 3:10 pm
by philbob
hi all so im new to the laser cutter iv googled and googled but im still unsure on the power for it ok so its a k40 off ebay it came with a 2 pin plug,then on the unit its got a 3 pin hole so could i use a uk 3pin plug on it and will it work right.thanks for any help from you guys

Re: power

Posted: Thu Nov 23, 2017 2:26 am
by ve3sqb
It will work but I would put a whole new cable on it and ground the case. It's always a wise electrical thing.