Chinese 50w “shadow” issue

General knowledge about laser here.

Moderator: baker

Post Reply
Shelly132
Posts: 1
Joined: Tue Jan 09, 2018 11:33 am

Chinese 50w “shadow” issue

Post by Shelly132 » Tue Jan 09, 2018 11:40 am

I am having this issue when I engraved anything faster than 100mm/s I get these “extras” at the right hand edge. I have googled the life out of it, anyone know the cause of this and how to fix? Thank you for any advice!
CFCF0C37-B477-44D9-839C-95A89C9F3331.jpeg
CFCF0C37-B477-44D9-839C-95A89C9F3331.jpeg (186.48 KiB) Viewed 3533 times

brianmichalk
Posts: 5
Joined: Tue Apr 10, 2018 3:56 pm

Re: Chinese 50w “shadow” issue

Post by brianmichalk » Tue Apr 10, 2018 4:04 pm

It's probably an alignment problem.

Post Reply