Page 1 of 1

Chinese 50w “shadow” issue

Posted: Tue Jan 09, 2018 11:40 am
by Shelly132
I am having this issue when I engraved anything faster than 100mm/s I get these “extras” at the right hand edge. I have googled the life out of it, anyone know the cause of this and how to fix? Thank you for any advice!
CFCF0C37-B477-44D9-839C-95A89C9F3331.jpeg
CFCF0C37-B477-44D9-839C-95A89C9F3331.jpeg (186.48 KiB) Viewed 4606 times

Re: Chinese 50w “shadow” issue

Posted: Tue Apr 10, 2018 4:04 pm
by brianmichalk
It's probably an alignment problem.