9 tips you should know when you operate a laser engraving machine

General knowledge about laser here.

Moderator: baker

Post Reply
BonnieStylecnc
Posts: 9
Joined: Sat Mar 03, 2018 6:48 am

9 tips you should know when you operate a laser engraving machine

Post by BonnieStylecnc » Sat Mar 10, 2018 8:46 am

When you use a laser engraving machine. You should pay attention to some basic When you use a laser engraving machine, you should pay attention to some basic operations and acquire some knowledge of safety, STYLECNC will take you to learn as the following nine tips.

1. When using automatic focal length, pay attention to the autofocus stick must be fastened, otherwise, the work table will be top to the laser.
2. When the Laser engraving machine is working, it is forbidden to open the cover.
3. The process of opening smoke, smoke blowing equipment.
4. When engraving wood and paper, we must pay attention to the engraving speed to avoid fire.
5. In the initial stage, the user first carries out red light positioning.
6. When processing thin boards and mutable materials, we should adjust the small 1mm of the variable amplitude water.
7. When cutting and machining, the workpiece should be used more than 2 centimeters from the worktable.
8. Reflection lens and focal lens cleaning: two fingers pinch the reflection lens. The other hand has a camera lens cleaning paper to clean the lens.
9. When the vector files are usually engraved, the resolution should be higher, and the resolution should be selected at a lower point when the object is engraved.

Original from www.stylecnc.com

Post Reply