Hi everyone, I have been downloading and trying new software since I purchased my ZGD3020
Some of the software has been trial an error. It seems to work with Lihiyu m2 board.
Although I knew some may not work I have found a couple that might with this control panel; however, I cannot tell which USB port is which in the device manager to enable the driver and I cannot see where on some of the software to put the device ID.
Please can anyone help with the following:
1. Suggestions for software that works with m2 and does both SVG and Bitmap but finds the origin easy.
2. How can I get my machine to talk to the software.
I am trying to avoid swapping out the controller at this stage due to cost.
Thanks for any help. ps, I don't use whats-app!
How to get software to communicate with laser
Moderator: baker