I am cutting a part that is 177mm wide, but when it comes out, it's about 176.3mm. Some of this is kerf (about 0.2mm diameter). But even if I account for kerf, the cut size is still off.
How can I specify the steps/mm of the system?
Thanks
Size wrong
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am
Re: Size wrong
Hi Matthew ,
Here is the troubleshooting link can solve you problem
http://www.thunderlaser.com/troubleshoo ... -size.html
Here is the troubleshooting link can solve you problem
http://www.thunderlaser.com/troubleshoo ... -size.html
Re: Size wrong
How do I know my password for vendor settings?