Thunder Laser Mars 90 Y axis stuck

Discuss laser machine here freely.

Moderator: baker

Post Reply
ron_ross
Posts: 1
Joined: Thu Jul 06, 2017 12:18 am

Thunder Laser Mars 90 Y axis stuck

Post by ron_ross »

After I plugged in the wrong rotary, My "Y" Axis is stuck. It still moves with the controlles but only about 5 inches or so. When I look at the controller its reading that its reached the table limit of 600mm, but its no where close to where the 600 should be reading. Its a MARS 90 900x600. It seems the controller thinks that its in end position for the Y axis, but its not.

I tried to reset it several times and I did not see any red lights on for the drivers. Also, Yes the Rotary switch is off.

Thanks

RR
Ben
Posts: 137
Joined: Tue May 24, 2016 9:06 am

Re: Thunder Laser Mars 90 Y axis stuck

Post by Ben »

Hi Ron,
OK,the Rotary switch is off,you should have it switched to "O".
Then the Y axis can be move,but it only moves under 5 inches or so,even press the reset button the Y aixs cannot move on the full 600mm,right?
Post Reply