Hi
I need some help again: Fitted a new power supply and the laser is now firing nicely but we have a problem setting the origin. In the past we could simply set the probe depth at any point on the bed and the laser head would begin cutting from there but now it seems to be setting itself according to where the image is on the software's work area. I cannot find the setting to reset this. Any ideas on this?
Thanks
Mike
Set Origin
Moderator: baker
Re: Set Origin
What controller do you use?If RDworks you can check the Config~system setting.You can change the laser head positiong in there.
Set Origin
That is probably why I could not find a good starter set. They seemed limited to me, mainly in the DCC controller.
Thank you guys.
Thank you guys.
I recommend trying [url=https://tradingrobotsite.wordpress.com/2017/08/eurusd-today-correction-in-long-term-to-fall.html]best forex trading system[/url] for profitable business
Re: Set Origin
I still do not receive a response,,,,,,, I need help
I need help, I need reset the laser machine Mars 130, what is the procedure? thanks
I need help, I need reset the laser machine Mars 130, what is the procedure? thanks
Re: Set Origin
I already did the steps to reset the laser machine but it still does not respond, can I do something else?
Re: Set Origin
eyyy I need support for Mars 130 Thunderlaser , someone that please support me
Set Origin
Thanks for the replies
I have another question : why arent the Rects properties from a SpriteRenderer changed when the scale is changed ?
I have another question : why arent the Rects properties from a SpriteRenderer changed when the scale is changed ?
I was advised this [url=http://expertadvisormt4ea.com/2017/06/forextrade-magic.html]best trading system[/url] for successful trading