Hello,
I have a problem with my machine. When the head is returning to the default position, it begins to be tearing/tugging, or sometimes even stops.
After this happens, the message line appears on the screen: "Hard Limit Prot. Please ESC".
Nothing helped fix this problem, like restarting the machine etc.
The video of the problem is below.
https://streamable.com/340lg
Thank you!
Problem Mars 1290
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: Problem Mars 1290
Have you reset Datum, it can do this if the controller is confused about the X=0 and y=0 position
does the controller show the correct size of the bed ie 1200x900
does the controller show the correct size of the bed ie 1200x900
Re: Problem Mars 1290
Hi Igor,
It seems that the limit switch is not working well.
Please check the Diagnoses from the LCD panel,see below. XLimit- is for X limit switch,YLimit- is for Y limit switch.please check the state are they working well.
Red: X limit switch is on.
Grey: X limit switch is off.
It seems that the limit switch is not working well.
Please check the Diagnoses from the LCD panel,see below. XLimit- is for X limit switch,YLimit- is for Y limit switch.please check the state are they working well.
Red: X limit switch is on.
Grey: X limit switch is off.
Re: Problem Mars 1290
Hello.
I would like to thank everyone for help, the issue is fixed.
The problem was a broken cable for limit switch. Maybe it would be better to use more flexible cable.
But I have another question. During cutting of a square 60x60 cm, the actual dimension/result is 59,7x60,3. How can fix this?
Thanks again!
I would like to thank everyone for help, the issue is fixed.
The problem was a broken cable for limit switch. Maybe it would be better to use more flexible cable.
But I have another question. During cutting of a square 60x60 cm, the actual dimension/result is 59,7x60,3. How can fix this?
Thanks again!