Help with settings for engraving text

Discuss laser machine here freely.

Moderator: baker

Post Reply
Dorrit05
Posts: 3
Joined: Fri Jan 11, 2019 11:48 pm

Help with settings for engraving text

Post by Dorrit05 »

Please excuse my complete ignorance but I have recently purchased a CO2 laser Machine Mantech 3050 60W. I intend to use it to laser engrave personalised text onto wooden brush handles which I will then colour infill.

I have only used the machine once and need to start testing different speed/power settings to get a clear and clean engraving without burning/staining the brush around the engraving. It needs to be deep enough to hold a colour infill using a lacquer stik but not too deep.

Can anyone offer some advice on the settings I should use. My first attempt it simply engraved the outline of the text which I believe is a vector engraving? However the type of engraving I want to achieve is not just the outline.

I have attached a picture of the effect I would like to achieve.

Many thanks
Attachments
39A89042-2BBF-4933-9593-AB3D6B6C8479.jpeg
39A89042-2BBF-4933-9593-AB3D6B6C8479.jpeg (214.09 KiB) Viewed 1393 times
User avatar
LINUS
Webmaster
Posts: 263
Joined: Tue Apr 28, 2015 3:55 am

Re: Help with settings for engraving text

Post by LINUS »

Yes,You need a vector design. And you need hight power low speeds,for exmple 50%power 200mm/s speeds
Because of major,be at ease so.
Dorrit05
Posts: 3
Joined: Fri Jan 11, 2019 11:48 pm

Re: Help with settings for engraving text

Post by Dorrit05 »

Thank you, I really appreciate your reply. I am using software called RD works that was installed along with the machine. I’m guessing that I can select a vector image option through that when I enter the text into the layer?

Again apologies for my lack of knowledge or experience.

Thanks
User avatar
LINUS
Webmaster
Posts: 263
Joined: Tue Apr 28, 2015 3:55 am

Re: Help with settings for engraving text

Post by LINUS »

Yes, that's right
Because of major,be at ease so.
Post Reply