Controller: TL-3120
Software: LaserCAD 7.98.15
100w, 700x500, china made generic chassis
Problem: When I start up machine it assumes the laser head is at 350 (X-position) and 250 (Y-position) no matter what the actual position is.
My attempts: I have tried setting the origins (1-4) using the key pad on the controller but it still assumes the head is at dead center. When I "read" the current position on my software it matches the machines reading of 350x250 no matter where the head is (position when the power was cut).
Please let me know if you have any advice or need further details. I'm dead in the water or the moment so any advice is very appreciated.
X-Y home position issue
Moderator: baker