Hi,
Is it possible to reduce laser burn mark on top surface due to fumes ?
When i cut mdf there is always a brown - yellow mark at the beginning of the cutting.
I tried to adjust with laser power (min max) or laser through mode but i didn't see any effects.
Best regards
Richard
MDF laser burn mark
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: MDF laser burn mark
If you cut the wood,I suggest you use the big air compressor to blow.
http://www.thunderlaser.com/features/hi ... essor.html
http://www.thunderlaser.com/features/hi ... essor.html