Set Origin
Posted: Wed Aug 23, 2017 7:14 am
Hi
I need some help again: Fitted a new power supply and the laser is now firing nicely but we have a problem setting the origin. In the past we could simply set the probe depth at any point on the bed and the laser head would begin cutting from there but now it seems to be setting itself according to where the image is on the software's work area. I cannot find the setting to reset this. Any ideas on this?
Thanks
Mike
I need some help again: Fitted a new power supply and the laser is now firing nicely but we have a problem setting the origin. In the past we could simply set the probe depth at any point on the bed and the laser head would begin cutting from there but now it seems to be setting itself according to where the image is on the software's work area. I cannot find the setting to reset this. Any ideas on this?
Thanks
Mike