Welcome to laserengraverforum.com!

Components in Chinese lasers- what's good, what's bad?

Discuss Laser Control Softwares here!

Moderator: baker

Post Reply
jensenbreck
Posts: 2
Joined: Tue Nov 07, 2017 6:06 am

Components in Chinese lasers- what's good, what's bad?

Post by jensenbreck » Tue Nov 14, 2017 2:34 pm

Hello,

I'm looking into Thunder Laser's Nova 24 laser cutter and have started to wonder about the components that make up Chinese lasers and which ones are good or not so good.

To start with, I'm wondering if there is a consensus on good, better, or best brands for the following:

1) Glass laser tube in the 60-80 watt range
2) The type of rail system used and component brand names for that
3) Laser power supply
4) Laser controller and firmware



I didn't find the right solution from the internet.
References:

http://www.cnczone.com/forums/general-l ... tware.html

infographic video

Chuck767
Posts: 1
Joined: Fri Nov 17, 2017 6:12 pm

Re: Components in Chinese lasers- what's good, what's bad?

Post by Chuck767 » Fri Nov 17, 2017 6:19 pm

I’m looking for a reputable place to buy a 120 W laser tube, do you know of any?

Post Reply