Nova24 engraving problem on X-Axis
Posted: Thu Mar 15, 2018 10:00 pm
Hello
I have a problem with engraving on X-axis - laser Nova24 60 Watt
Engraving is very low quality (please see photos in the attachment) For engraving we use the following settings: Scan mode, 400 mm/s speed, 15 power and interval 0,08mm. This problem occurs on each material.
But when engraving on Y-axis the engraving is good quality
Earlier there was no problem with the quality of the engraver on X-axis .
What can be a problem ?
I am asking for help and instructions how to solve the problem?
I will be gratefull for any answer.
Regards
marek-xx
I have a problem with engraving on X-axis - laser Nova24 60 Watt
Engraving is very low quality (please see photos in the attachment) For engraving we use the following settings: Scan mode, 400 mm/s speed, 15 power and interval 0,08mm. This problem occurs on each material.
But when engraving on Y-axis the engraving is good quality
Earlier there was no problem with the quality of the engraver on X-axis .
What can be a problem ?
I am asking for help and instructions how to solve the problem?
I will be gratefull for any answer.
Regards
marek-xx