Loss of Power!!!!
Posted: Mon Jun 18, 2018 12:21 am
Today my laser stop cutting through 6mm Birch Plywood and 6mm MDF.
I've check the alignment of all the mirrors and that's all perfect and Clean.
I also pulsed into the 10mm acrylic and that was perfectly straight.
I also checked the power supply and pressed the test button and got the green light.
In order for me to cut I had to set the laser @95% Power and Speed of 3.
The laser has 1000 Hours on the tube. The laser is 2 years old.
The mA meter reads 23.
Could I have a bad tube???
Or is the power supply gone bad??
Thanks for the help
Steven
I've check the alignment of all the mirrors and that's all perfect and Clean.
I also pulsed into the 10mm acrylic and that was perfectly straight.
I also checked the power supply and pressed the test button and got the green light.
In order for me to cut I had to set the laser @95% Power and Speed of 3.
The laser has 1000 Hours on the tube. The laser is 2 years old.
The mA meter reads 23.
Could I have a bad tube???
Or is the power supply gone bad??
Thanks for the help
Steven