Laser Engraver Forum

I had my laser working a few weeks ago and now nothing. I tried to install the driver for my DK-8-KZ and it will not install. I know this because when I hit the uninstall it says nothing is installed. When I launch the software that came with it, it just sits at trying to connect and has a link to install driver. I tried to use EzGraver and when I launch it, it open but no ability to connect to the device as it is not listed. Is there a way to force install the ch341SER.INF driver to get this working again, or do you all know of another way I can get this working again?

Thank Hive

John

Sorry didn't check the box to send me an email for the reply