Laser Engraver Forum

Hi, my name is Sidney i´m from Brazil e I have a cut laser machine that use a MPC 6525 module from Leetro.

I´m with a serios problem. My machine doesn´t execute the cut anymore. When I send a commad to CUT Contour the machine executes it perfectly, when I send a command TEST, the machine execute the command too, but when I send a command Start/Pause, the machine starts the command, stops the car in a start position and blocks any command on the display interface.

May someone help me?

Hello Sidney:
This is zoe from Hitec Group,its a pity to hear your problems.
According your description，our enginners said your control panel maybe have problem.
But still need a detials video to show the problems.
My EMAIL :info@hiteccnc.com
Whatsapp/wechat +86 13181737002
Web:www.hiteccnc.com

Any quesitons feel free to contact me.

Thanks for the answer I found the problem.
The ground cable, it was broken.

The machine ran for 2 months and locked again.

Please, the problem happened again.
I sent an email to the address mentioned, but I got no response. This Email contains a short video that shows the problem.
I also researched Interet and found a similar problem in 2013.
https://www.cnczone.com/forums/general- ... tware.html

Thanks.