I have noticed that during cutting the 4 small fans, on each side of the machine (that are for cooling the electronics), are blowing laser fumes out into my room. I am wondering if that is the correct direction for them to be blowing (out rather than in).
Also, would it hurt anything if I turned them around so they blow inwards, towards the electronics.
Thank you
Fume Extraction
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
-
Thunder laser - Tom
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Fume Extraction
That's no problem.