How can I get the best results from the laser cutting machine?

[perfectlaserChina]

1.The cooling system should be grounded, and the water tank and waterway should be cleaned frequently. The temperature control point of the cooling temperature control water tank should be fair. Otherwise, the laser tube will be easily damaged and the dew condensation power will drop, the cold head of the tube will fall off, the service life will be shortened, and sometimes it will not work and you have to constantly change the tube.

2.The laser tube installation fulcrum of the laser cutting machine should be reasonable. The fulcrum should be at 1/4 of the total length of the laser tube. Otherwise, the laser tube spot pattern will be deteriorated. Some working spots will become several points for a period of time, causing the laser power to drop and unable to meet the requirements. This results in constant change of management.

3.The suction device should be checked and cleaned on time. Otherwise, a lot of smoke and dust can not be discharged, and the lens and the laser tube are seriously and quickly contaminated, so that the mechanical and electronic components are easily oxidized and the contact is not good.

4. If laser cutting machine work for a while, the frame will have a fever, the surface of the lens will be discolored and rusted; the film cracking is the object to be replaced, especially for many customers using atmospheric pumps and air compressors. This results in rapid accumulation of water on the focusing lens, so it is necessary to check the cleaning and quality of the lens path system on time.

5.The working environment of the laser cutting machine can not be too bad, if the ambient temperature is higher than 30 degrees, below 18 degrees, there are too much dust, severe air pollution, the machine will be severely damaged, the failure rate will rise; the electrical accessories in the humid environment itself is easy to go wrong.

For more fiber laser cutting information, please visit the website www.perfectlaser.net.