Laser Engraver Forum

Question, i wanna know about settings of my co2 laser.

I know i can set up speed and power of the laser, but also can setup frequency of the laserbeam??

Is that possible to change? And what are the min/max of that settings normally?


I hope someone can help.

Kind regards.

The Brand will show you the min/max, you can change this by software like lightburn or rdworks. Because not sure which machine do you have.

hello,
usually co2 work around 20kHz - 25kHz frequency,
usually you cannot change it, but if you have co2 like Keyence co2 machine ML-Z version, software allows you to make a small adjustment,
however, generally for lasers below 10G - no frequency changes.