Engraving blank coins, but the position kept moving.
Posted: Thu Jun 02, 2022 3:57 pm
I got some cut out blank aluminum coins that I want to engrave. I place the coin on the cutting board, and each time I engrave it, the position is slightly off. Individually, I could not tell if its not perfectly aligned. But by comparing the engraved coins with each other, it becomes obvious they are not the same. Not to mention there is even a back side of the coin.
Is there a laser engravement machine that can first scan the shape of the material, and then automatically laser engrave on it?
Is there a laser engravement machine that can first scan the shape of the material, and then automatically laser engrave on it?