Today we are talking about software-controlled laser source. It is 450nm Blue fiber coupled laser source controlled by software. EasyHost is the control software. The connection between the laser and PC software adopts the communication protocol of RS232. The laser supports two working modes: CW/Modulation. When switching to Modulation, an external signal input is required. This is a fiber-coupled laser, and a free-space output laser can also be customized. Let's check it now.
Youtube:
https://youtu.be/l_wBLa3ywHY
- 450nm-1.5w-fc-laser-software-control (1).jpg (70.06 KiB) Viewed 10162 times
It is 532nm DPSS laser source. This laser source can be controlled by software. The connection of the laser and the PC software, using the RS232 communication protocol. The laser supports two modes of operation CW/Modulation, and an external signal input is required when switching to Modulation. Here is the free space output, and it is also possible to customize the fiber-coupled laser.
Youtube:
https://youtu.be/9Qkd3cBqLHE
- 4.jpg (55.34 KiB) Viewed 10162 times
- 5.jpg (39.42 KiB) Viewed 10162 times
Software operation.
Click the [Open COM] button to connect the control circuit on the laser.
Multiple laser operating parameters can be viewed/set in the software.
As a special reminder, it is necessary to set a maximum working current parameter according to the current laser first, so as to avoid the current of the later regulation being too high and damaging the laser.
Four short words sum up what has lifted most successful individuals above the crowd: a little bit more.
