Laser Engraver Forum

delay really >> extends work time of fan 1-20 min after end of work..

So delay really have 3 inputs and 2 outputs.
+24V GND and signal


So it should be simple 3 connections to ruida GND Wind and +24V... but no.
The output of wind/status is GND not +24V signal used by relay.

So now I need put a another really to connect Signal input of time relay with 24V

In final is 3 cables going to relay's there is 6 cables connecting 2 really together and 2 output cables.
11 cables mess that works.

Don't tell me that you can just set delay time in Lightburn for status and wind output.

It sounds like you're experiencing some difficulty connecting a Ruida controller with a time delay relay. While you work through that, consider exploring the Monport laser as an alternative. Monport lasers are renowned for their user-friendliness, top-notch quality, and affordability. You can check out their products https://monportlaser.com/collections/co ... ka374VZjm3 They might offer a smoother experience compared to your current setup and could potentially address any frustrations you're encountering with the time delay relay integration.