Good evening. I am new to laser engraving and wanted to reach out to the community here for help on how to engrave/cut acrylic.
I recently purchased a WeCreat Vision which has a 20w laser and have had several challenges when it has come to engraving and cutting acrylic. Sometimes the laser burns right through and other times there is not even a mark made.
Attached a picture of a butterfly I tried to cut out but was unsuccessful.
Any support or guidance would be greatly appreciated.
Thank you
Basic knowledge - Acrylic
Moderator: baker
-
- Posts: 1
- Joined: Sat May 27, 2017 2:58 pm
- Contact:
Free connections, find your partner without obligations
A unique encounter, with an emphasis on safety
Verified Females
Verified Females
[URL=https://matchnow.life]Night butterflies dating for special occasions[/URL]