CypCut Laser Cutting Control System

Discuss Laser Control Softwares here!

Moderator: baker

Post Reply
User avatar
LINUS
Webmaster
Posts: 234
Joined: Tue Apr 28, 2015 3:55 am

CypCut Laser Cutting Control System

Post by LINUS » Fri Aug 28, 2015 3:17 am

Thank you for using CypCut laser cutting control system.
CypCut laser cutting control system (CypCut for short) is a set of system software designed for
plane laser cutting, including laser cutting process, common layout function and laser processing
control, most of its functions are applied in graphics processing, parameter settings, custom cutting
process editing, layout, path layer planning, simulation and cutting process control.
CypCut software can realize process control only if used with Dog and Control Card.
CypCut will enter DEMO mode while running on a computer without Dog, so that you can get
all other functions except process control for normal use. Therefore, CypCut can be installed in a
separate notebook for the design before processing.
Please note that this User Manual is only for instructions of main program about CypCut
software.
Please refer to other Manuals or contact us for the details of other tools installed with CypCut
software, such as platform configuration tool.
The Document is drawn up based on Version 6.3.486 of CypCut. As product functions are being
updated, there may be some differences between your product and the Manual. We will apologize for
such inconvenience.
Please feel free to contact us with any questions or suggestions you may have.
Download:
CypCut User Manual V6.2.5.pdf
(1.15 MiB) Downloaded 1215 times
CypCut6.3.635.8.zip
(24.21 MiB) Downloaded 2596 times

krish.rohila
Posts: 1
Joined: Thu Jul 14, 2016 10:55 am

Re: CypCut Laser Cutting Control System

Post by krish.rohila » Thu Jul 14, 2016 11:05 am

Hello,
I have been trying to use the cypcut software for quite some time. I want to cut different metals of thickness from 1mm to 6mm. However I have not been able to achieve a goof finish while cutting. The smoothness isn't good. Can you please help me with the parameters that are to be set to cut metals of different thickness. Metal is normally stainless steel, carbon steel, aluminium, copper, brass of above mentioned thickness. Please help me with the layer parameters so that I will be able to start my work. Thanks in anticipation.

Post Reply