Thunder mini60 engraving problem
Posted: Mon Oct 26, 2015 3:32 am
Dear Tom
i have problem with my thunder mini60 laser machine .
yesterday when i started the machine , the laser head went to is home origine and the axe motor made noise because it couldn't stop when it went to the back of table . then the axe was blocked and cannot move . so i restarted the machine , and the axe motor made noise again . even i pushed X/Y motor axe button i had the same problem , motor didin't stop.
i moved the laser head many time and the machine find his good position , and axe motor can stop hitself.
but now the engraving is very bad , there are many lines didn't engraved .
i cleaned mirrors and len , i replaced the laser tube ,the problem stay the same .
i took video and picture to show you . i hope for your help please .
best regards
Lance weisman
i have problem with my thunder mini60 laser machine .
yesterday when i started the machine , the laser head went to is home origine and the axe motor made noise because it couldn't stop when it went to the back of table . then the axe was blocked and cannot move . so i restarted the machine , and the axe motor made noise again . even i pushed X/Y motor axe button i had the same problem , motor didin't stop.
i moved the laser head many time and the machine find his good position , and axe motor can stop hitself.
but now the engraving is very bad , there are many lines didn't engraved .
i cleaned mirrors and len , i replaced the laser tube ,the problem stay the same .
i took video and picture to show you . i hope for your help please .
best regards
Lance weisman