how can i change the autofocos level ? Standard 4,5mm
and did someone have distance Information?
Standart Lens = 4,5mm
4” laser head = ?? mm
HR head = ?? mm
best regards
Stefan
Thunderlaser Mini 60
Autofocus level--20160219
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am
Re: Autofocus level
Hi Stefan,
as you know, different laser head has different focus lenses,
if you still want to use the auto focus, you can change the setting on software.
the focus distance of standard head is 5~6.5mm,
HR head is 3~4mm,
4" head is 9~11mm.
http://www.thunderlaser.com/products/la ... ation.html
about how to change the setting on our RDWorksV8, please check the picture.
as you know, different laser head has different focus lenses,
if you still want to use the auto focus, you can change the setting on software.
the focus distance of standard head is 5~6.5mm,
HR head is 3~4mm,
4" head is 9~11mm.
http://www.thunderlaser.com/products/la ... ation.html
about how to change the setting on our RDWorksV8, please check the picture.
- Attachments
-
- setting.png (10.15 KiB) Viewed 4856 times
-
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Autofocus level
Hi Stefan
The focus distance of standard head is 6mm, but you set that user's setting is to 4.5-5mm is ok
Because of the auto focus has no need touching the material that will detect the material between 1mm
The HR laser head must be use manual adjust that focus distance, it is not support with use auto focus function
The 4'' laser head just be set to 9mm in the user's setting.
The focus distance of standard head is 6mm, but you set that user's setting is to 4.5-5mm is ok
Because of the auto focus has no need touching the material that will detect the material between 1mm
The HR laser head must be use manual adjust that focus distance, it is not support with use auto focus function
The 4'' laser head just be set to 9mm in the user's setting.