Page 2 of 2
Re: Not accurate cutting problem.
Posted: Wed Sep 21, 2016 10:44 pm
by Young
Hey Ben!
Thank you for your quick reply.
Here is a photo.
We cut a bear shape which is a symmetrical shape.
We cut it in a half. It means that two half of bear shape should be the same.
But, there are differences. the gap is 2~2.5mm.
We checked the level of the cutting board again. And, it is ok.
And, the bear shape cut in left part of cutting bed is symmetrical.
Re: Not accurate cutting problem.
Posted: Thu Sep 22, 2016 12:47 am
by Ben
Hi Joon,
Thanks for your picture.
Okay, the gap is 0.2~0.25mm.
please create a circle by RDworks and cut it, if it is the same problem.
Re: Not accurate cutting problem.
Posted: Thu Oct 13, 2016 10:11 pm
by Young
Hey.
Thanks for your suggestion.
I was too busy to have a test.
So, I have just taken a test.
I drew the circle in Laser program you provided.
And cut the circle.
You might see the differences.
The difference is 1mm.
Is that a problem? If it is, do you have any suggestion to solve the problem?
Thanks in advance.
Joon
Re: Not accurate cutting problem.
Posted: Tue Oct 18, 2016 2:25 am
by Ben
Hi Jooh,
sorry for our late reply.
For your problem,there are still three checking you can do.
1.make sure the belt is tight enough;
2.find below link to improve the problem.
http://www.thunderlaser.com/troubleshoo ... -size.html
3.cut a 150×150 square,check if the diagonal is equal.
- square.png (399.28 KiB) Viewed 5265 times
Re: Not accurate cutting problem.
Posted: Wed Dec 07, 2016 2:44 am
by Young
Hey,
Please, let me know the vendor password.
Re: Not accurate cutting problem.
Posted: Wed Dec 07, 2016 8:55 am
by Thunder Laser -Nolan
rd8888