Hello everyone ,
i have a 50w Chinese laser that was working fine, during the last job while sliding up the Y axis I heard a little clunk, the machine froze up. So after a while I turned it off , now it won't initialize, all I get on the display is connecting to controller message, I am getting desperate, any help would be apreciatade, thank you in advance for any help, tips or ideas.
-Connecting to controller
Moderator: baker
-
- Posts: 6
- Joined: Sat Aug 08, 2015 10:29 pm
-Connecting to controller
[url=http://www.efronzac.com/biografy]Фильмография и биография Зака Эфрона[/url]
-
- Posts: 2
- Joined: Sat Aug 08, 2015 11:02 pm
Re: -Connecting to controller
Any info about this machine would help.