Help for k40 laser engraver/cutter

[Geraldol]

Hello,

I am new in this engraving hobby and need a lot of help.
i started the engraving, but, after 10-20 seconds it is fading.

Please, see picture

also, what are the steps for engraving and cutting at the same time?
Step by step instructions please, since this is my first time.

[Geraldol]

HI THERE
FIRST YOU NEED TO ALLIGNE YOUR BEAM. next you only can do one at the time first engraving then cutting to be selected in the layer menue ( right side it works from top to bottom.)
send me a PM then I can send you picture instruction to align the beam.
greetings

[Otjrbsefz]

Hello, I couldn't send you a PM.
I ll try to align the beam in the morning.

Do you know where I could get step by step (for dummies!) instructions on how to cut?
Thank you do much