Hi,
I know that what i'm asking is very unusual, but let me try to explain.
I have a cheap chinese laser 50W with 50 x 30 cms cutting area, and it works like a charm for 2 years without any problem, sometimes 8 hours a day for 5 days a week, believe it or not.
One client ask me to cut a piece of 502.6mm wide, so as you image does not cut on the table that cuts only 500mm.
If I can adjust the setup to 503mm x 300mm i will be able to cut this file and keep the client........
I use Laserworks 6.00.44 software and try to change settings to "cheat the machine" in 3 or 4 mm. In the machine there is enough space for it.
In the software there is a page setting that I already did the change, but still not accepting and the machine control panel says "SLOP OVER"
Is there a way to increase this area in 3 or 4mm?
I appreciate any help or idea.
Is there a way to oversize the table of a chinese laser 50W 50 x 30 in 5mm?
Moderator: baker
-
- Posts: 4
- Joined: Wed Nov 18, 2015 12:48 pm
Re: Is there a way to oversize the table of a chinese laser 50W 50 x 30 in 5mm?
Go into to vender settings and adjust the Breadth setting for each the x and the y I have mine set to 525 X and 325 Y that gives me almost an inch each way On mine the vender password is RD8888
Re: Is there a way to oversize the table of a chinese laser 50W 50 x 30 in 5mm?
Fixtureman1,
YOU ARE THE MAN!!!!!!!!!
Problem Solved.
Thank You, Thank you and Thank You, you save my day!
YOU ARE THE MAN!!!!!!!!!
Problem Solved.
Thank You, Thank you and Thank You, you save my day!
Re: Is there a way to oversize the table of a chinese laser 50W 50 x 30 in 5mm?
thanks fixtureman1, great tip!