Hi Jasper_Rullman
you can mirror and rotate your image when using the rotary table.
Rotate 90 or 270 degree and do the Horz mirror or Vert mirrror to get the correct orientation you wanted,
and then save the file as that orientation so you not need to do it again when you reuse this file.Ok?
3D engrave
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
- Jasper_Rullman
- Posts: 11
- Joined: Fri May 15, 2015 2:48 am
Re: 3D engrave
Thank you for the information, I just wanted to be 100% clear, it is expected to have to have to Mirror any image to be used with the rotary table. Just surprised that is not documented in the RDWorks Manual.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am
Re: 3D engrave
Hi Jasper_Rullman
Thanks for you suggested.
it will help us to improve our software.
Hoping you everything is well.
Thanks for you suggested.
it will help us to improve our software.
Hoping you everything is well.