Shadow each layer ? EZcad

Discuss Laser Control Softwares here!

Moderator: baker

Post Reply
narbox
Posts: 1
Joined: Fri Nov 29, 2019 12:01 pm

Shadow each layer ? EZcad

Post by narbox »

Hello,
I have a 30w fiber laser, speed 500 , power 50%
It's a new issue that just started happening.
When I select text to engrave, it does a 3 pass over.
each time it seems to be moving to create a shadow effect.
When I do one line of text, it does not do it.
Does anyone know why? I have check every setting, but can't find a reason why it moves each pass over?
Any help would be appreciated

This never happed before today, I did a reset, no joy..
It moves 1mm up and 0.5mm back each flyby
Has anyone seen this before
Post Reply