New laser, should I set max-power and how?

General knowledge about laser here.

Moderator: baker

Post Reply
apmadsen
Posts: 1
Joined: Thu Jan 07, 2021 1:57 pm

New laser, should I set max-power and how?

Post by apmadsen »

I've recently got a 50W chinese co2 laser, and all the videos I've seen, says that the first thing I should do, is setup the max power, but is this necessary with a Ruida RDC6442G-B controller (the laser has no amp-meter)?

And if it is indeed necessary, how do I calculate the correct value? The power supply is 60W, so should i calculate it as 50/60 = 83%?

Regards, Anders Madsen
buksie83
Posts: 2
Joined: Sun Aug 22, 2021 8:23 am

Re: New laser, should I set max-power and how?

Post by buksie83 »

Same question here, someone has info?
Post Reply