Hello,
I am new in this engraving hobby and need a lot of help.
i started the engraving, but, after 10-20 seconds it is fading.
Please, see picture
also, what are the steps for engraving and cutting at the same time?
Step by step instructions please, since this is my first time.
Help for k40 laser engraver/cutter
Moderator: baker
Help for k40 laser engraver/cutter
http://globalmarble.com.au/index.php?option=com_k2&view=itemlist&task=user&id=220038
Re: Help for k40 laser engraver/cutter
HI THERE
FIRST YOU NEED TO ALLIGNE YOUR BEAM. next you only can do one at the time first engraving then cutting to be selected in the layer menue ( right side it works from top to bottom.)
send me a PM then I can send you picture instruction to align the beam.
greetings
FIRST YOU NEED TO ALLIGNE YOUR BEAM. next you only can do one at the time first engraving then cutting to be selected in the layer menue ( right side it works from top to bottom.)
send me a PM then I can send you picture instruction to align the beam.
greetings
http://globalmarble.com.au/index.php?option=com_k2&view=itemlist&task=user&id=220038
Re: Help for k40 laser engraver/cutter
Hello, I couldn't send you a PM.
I ll try to align the beam in the morning.
Do you know where I could get step by step (for dummies!) instructions on how to cut?
Thank you do much
I ll try to align the beam in the morning.
Do you know where I could get step by step (for dummies!) instructions on how to cut?
Thank you do much
планшетный [url=http://www.gorodservis.ru/nazvan-indesit.html]искровой ремонт холодильников Индезит[/url] не бедно