I have a 15000 mw (closer to 7.5-8 watts RMS) 2 Axis for now, variable laser power.
I intend to use it to cut foam board that is 4.5mm thick with a brown paper backing on both sides. (Adams Mark)
I have a 3d printer so I am familiar with slicing and Gcode, I use Simply3D.
I need to be able to do the following:
1) Just etch the top surface.
2) Just cut the first layer of paper.
3) Cut the first layer of paper and 1/2- 3/4 of the foam material
4) Cut att three layers.
Would I have to run the print 4 times, or is there software that will allow you to define, that a red line on the image should be etched, maybe a blue line is top surface cut, A green line is a mid cut, and a black line is a 100% cut?
I am hoping there is something out there that will easily accomplish this. I do not mind having to pay for it if it will work.
What software will do this?
Moderator: baker
What software will do this
I have purchased new laptop and want to install best antivirus software so, What is best software to remove antivirus .?
[url=http://avante.biz/category/products/]avante.biz[/url]