Laser Engraver Forum

I have an Open build Acro 1010 machine.
I am looking for a 1500mw or better 405nm laser module for it.
I have the driver, and air cooled heat sink for it, I just need a good module. I don't trust any of these Chinese ones with their inflated specs.
Looking to replace my 10 watt 455nm laser I am currently using. It does not do well with white foam board.
Anyone seen a good one out there?

Thanks

It's a pity that there are very few people in this forum and may not be able to help you.I want to help you, but I don't have any knowledge about this.sorry