Laser Engraver Forum

Hi all,

I am newbie here as well as with engraving.

I have just done a engraving on my full grain leather wallet however I want to make the engraved part standout. The black burned leather is just getting light as I clean it with wipes.

Any way I can enhance the engraving to make it stand out ? Any black color or something that I can apply that should enhance the engraved part but it shouldnt effect the non-engraved part?

Picture attached.

PS. In the attached picture, I haven't cleaned it after laser engraving yet with wet wipes as the black burned part spreads over when I move my finger on it. To get rid of it, I clean it with just wet wipes but that literally dulls the engraving (black part). That's why I need it make the engraving stand out.

Many thanks for any help.

I have never tried this, but if I did I would use Black Shoe polish or something like that for leather.

About leather carving, should be in the laser software, the laser frequency of the appropriate speed, laser power can only be between 10-20%, you can try
My email address is yubangying1985@163.com